Jerith’s technologically-advanced powder coating system allows us to produce a high quality, long-lasting finish which is also environmentally friendly. When applied to a Jerith fence, FencCoat is twice the thickness and hardness of a typical acrylic (or “wet paint”) finish. Consequently, it is far more durable, fade-resistant, and scratch-resistant than other coatings.

Since its introduction in North America almost 40 years ago, powder coating has become the fastest growing finishing technology. Powder coating contains no solvents and therefore emits negligible amounts of volatile organic compounds (VOC’s) into the atmosphere. Wet paints, however, cause severe pollution, both through the emission of VOC’s when they are cured and by the generation of excess paint which is considered a hazardous waste. In addition, Jerith’s aluminum is prepared for its FencCoat finish with an environmentally safe pretreatment, unlike most wet paints.

To prove the durability of our powder coating, we have tested it extensively. FencCoat endured 3,000 hours of harsh salt-spray and humidity resistance, as well as 5 years of continuous exposure in Florida. Other aluminum fence manufacturers have performed similar tests on their own coatings, yet they only survived 1,000 hours of salt-spray and humidity testing and 1 year of Florida exposure (as stated in their literature). That is why we are confident enough to guarantee that our FencCoat finish will last for as long as you own your Jerith aluminum fence.

Jerith Patriot Fence Limited Warranty

As a leading manufacturer of quality fence products, Jerith Manufacturing Co., Inc. warrants that the FencCoatTM finish on its Patriot Ornamental Wire Fences will not peel, crack, chip, or blister for a period of 8 years from the initial purchase date. Jerith also warrants that its wire fences will be free from defects in workmanship and materials for the same period.

This warranty does not extend to damage caused by improper application, installation, or use; abuse; accident; alteration; negligence; or acts of God. There are no other express warranties except as stated herein. This warranty is issued to the original purchaser and is not transferable. This warranty must be registered within 30 days of installation with Jerith.

If the product should fail to conform with this warranty, Jerith shall repair or replace the defective parts at its discretion. The purchaser shall provide Jerith with written notice of the failure, along with proof of purchase, and the nature of the defect. Jerith reserves the right to inspect the material at its plant to determine the validity of a claim. If it is valid, all removal and re-installation costs of the materials are the responsibility of the purchaser.

The above constitutes the complete warranty by Jerith and no other agreement, written or implied, is valid. No person is authorized to change or modify this warranty. Recovery for consequential or incidental damages are hereby excluded. This warranty gives you certain specific legal rights, and you may also have other rights which vary from state to state.

Enjoy Your Jerith Fence!

Jerith® Lifetime Limited Warranty

As a leading manufacturer of quality fence products, Jerith Manufacturing Co., Inc. warrants that the FencCoatTM finish on its aluminum fences will not peel, crack, chip, or blister for as long as you own the product. Jerith also warrants that its aluminum fences will be free from defects in workmanship and materials for the same period, and they will never rust.

This warranty does not extend to damage caused by improper application, installation, or use; abuse; accident; alteration; negligence; or acts of God. There are no other express warranties except as stated herein. This warranty is issued to the original purchaser and is not transferable. This warranty must be registered within 30 days of installation with Jerith.

If the product should fail to conform with this warranty, Jerith shall repair, replace, or refund the original purchase price of the defective parts at its discretion. To file a claim under this warranty, you must provide Jerith with written notice and photographs of the failure, proof of purchase, and the nature of the defect. Jerith reserves the right to inspect the material at its facility to determine the validity of a claim. If it is valid, removal and re-installation costs of the materials are the responsibility of the purchaser.

The above constitutes the complete warranty by Jerith and no other agreement, written or implied, is valid. No person is authorized to change or modify this warranty. Any recovery is limited to the actual original purchase price of the affected Jerith fence or fence component(s) and excludes any costs for labor or third party supplies required for removal or installation. Recovery for consequential or incidental damages, attorney’s fees and costs are hereby excluded. This warranty gives you certain specific legal rights, and you may also have other rights which vary from state to state.

Enjoy Your Jerith Fence!

Through extensive research and testing, Jerith has developed an aluminum alloy called HS-35. This remarkable material has the strength of steel without the rust!

Our HS-35 Alloy has a minimum yield strength of 35,000 pounds per square inch (psi), which is significantly higher than the 25,000-33,000 psi strength found in most steel fences. Even more impressive is Jerith’s advantage over other aluminum fences, which have yield strengths of only 16,000 psi.

Every post and rail in Jerith aluminum fences is extruded from our exclusive HS-35 Alloy. While some aluminum fence manufacturers claim to use similar alloys, they seldom use it in both their posts and rails like we do. In addition, Jerith is the only manufacturer that uses a high strength alloy in its pickets. Our pickets are over 50% stronger than any other aluminum fence. We don’t cut corners on the strength of our products!

An independent testing laboratory has proven that a typical Jerith Residential Fence can support over 350 pounds per section without any structural failure and our Industrial fence can hold over 1,000 pounds!

With strength like this, Jerith fences will certainly satisfy your fencing needs for years to come.

The industry name for HS-35 is 6005-T5.

Aluminum fence alloy 6005-T5 is the standard makup of aluminum that is industry standard. Aluminum extrusions for your fence of Alloy 6005-T5 with minimum yield strength of 35,000 PSI. But what makes up 6005-T6?

Aluminum extrusions for your fence of Alloy 6005-T5 with minimum yield strength of 35,000 PSI.

My phone is always ringing off the hook and one the questions I get a lot is “how do I know I am going to actually receive a real Jerith fence?”. People are getting weary of buying over the internet and have been victims of bait and switch. How do you know if your fence is really manufactured by Jerith Manufacturing Company, Inc?

Jerith goes to great price in order to make sure their customers are getting the “Jerith” name brand. If you already have a aluminum fence and you want to know if its a Jerith fence, or if you are buying a fence and you want to know how to see if you are a victim of bait and switch then this is what you need to look for.

How can I tell if I received genuine Jerith products?

Gates – the two top caps on the sides of a gate have the logo

Posts – our standard flat post caps have a raised Jerith logo. (Note: Ball caps do NOT have a logo on them.)

Sections – the Jerith logo is stamped into one end of each horizontal rail

As you can see it is very easy to quickly find out if the Jerith fence you just bought it really a Jerith Aluminum Fence.

If you don’t see the Jerith logo in all of these places, please contact our Customer Service Department at 800-344-2242 because you may not have genuine Jerith products!